SuiteFactory™
Enterprise Class Solutions
by CAD/CAM Integration, Inc.
 

 Take control of your office or shop: engineering, manufacturing, legal, medical . . .

Available in English, Chinese, Japanese and Spanish Language Editions

  

 

 

Home
Up
FT-BTRtm
DNC/Switch/LED Connector (J2) Facit Punch Connector (J5)
Connect to cable shield drain wire1 Protective GND
For CNC’s with Serial Punch outputs 2 Serial Punch In
Used for testing and special applications3 Serial Out
Return for Serial In/Out signals7 Signal GND
Open=DNC, Closed=PTR 8 DNC/PTR Switch
Return for DNC/PTR switch 22 Signal GND
Rewinds program stored in BTR memory9 Rewind Pushbutton
Clears program and gets next one Q’d 21 Reset Pushbutton
Return for Rewind and Reset switched 18 Signal GND
Signal light to indicate date flow to CNC10 Run LED
Power for external LED 22 +5V for LED
To DNC COM port CTS 14 READY
To DNC COM port RD 15 To DNC
To DNC COM port GND 16 Signal GND
To DNC COM port TD 17 From DNC
Data channel 11 CH1
Data channel 22 CH2
Data channel 313 CH3
Data channel 44 CH4
Data channel 55 CH5
Data channel 66 CH6
Data channel 77 CH7
Data channel 88 CH8
Punch Initiate11 P1
Punch Ready12 PR
Ext. Pullup Resistor23 Ext. pullout
+5v for some Fanuc CNC’s24 +5V
SD signal10 Signal GND
ERR 1 signal20 Signal GND
TL signal21 Signal GND
0 volts25 Signal GND
Motherboard Jumpers
* Factory Defaults
W1A*Run signal from the NC/CNC is a level. Most controls are this way. Remove jumper from W1B
W1BRun signal from the NC/CNC is a pulse. K&T controls are this way. Remove jumper from W1A
W2Puts +5 volts on the Facit punch input connector, J5 pin 24. For some older Fanuc CNC’s.
W3A*Puts a 470 ohm resistor on the Facit Punch input connector, J5 pin 12, Punch Ready pulled up to +5 volts. Remove jumper from W3B.
W3BPuts a 1.5K resistor on the Facit Punch input connector, J5 pin 12, Punch Ready pulled up to an externally applied voltage on J5 pin 23. Remove jumper from W3A.
W4*Connects a .0022 noise filter capacitor between Facit punch input connector, J5 pin 11 and Signal GND.
W5Makes the Serial In signal available to personality cards. Special use only.
W6Makes the Serial Out signal available to personality cards. Special use only.
CAD/CAM Integration, Inc.
76 Winn Street Woburn, MA 01801
Tel: 781-933-9500
Fax:781-933-9238
Email: sales@suitefactory.com

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Home Up Next